Shop Technician

Posted: Thursday, 27 March 2025
Valid Thru: Saturday, 26 April 2025
Index Requested on: 03/27/2025 13:26:54
Indexed on: 03/27/2025 13:26:54

Location: Garner, NC, 27529, US

Industry: Construction/Landscaping
Occupational Category: 49-9021.00 - Installation, Maintenance, and Repair
Type of Employment: FULL_TIME

Gregory Poole is hiring!

Description:

PRIMARY FUNCTION:

The primary function of this position it to perform advanced systems repair and assembly by performing independent trouble shooting using various diagnostic equipment and manuals.


ESSENTIAL DUTIES:

  • Check the equipment and supplies required to perform the work scheduled, comply with PPE requirements, and otherwise prepare for duties.
  • Uses manuals, repair manuals, parts manuals, parts diagrams to perform independent troubleshooting and repair of construction equipment.
  • Uses lift trucks, overhead cranes, & other aides to lift or move parts into position to be repaired.
  • Check in and in bound Equipment.
  • Clean and Organize Shop and Tooling
  • Uses hand & power tools to remove, install, replace, re-build, repair, & test parts/equipment on construction equipment.
  • Uses miscellaneous resources and computers to reference parts, get information about parts & enter data into record systems.
  • Uses tools to disassemble/re assemble parts or equipment; cleans parts with rags, cleaners, power washer; uses test equipment to make diagnostic checks; and controls powered equipment or tools to make repairs.
  • Climbs up onto, under, & into vehicles to gain access to all parts of vehicle.
  • Uses overhead hoists, lift devices, forklifts & other aides to move items off vehicle to move parts to locations for disassembly, repair, then back to the vehicle for reassembly.
  • Proficient at performing inspections, do preventative maintenance, repair Electric Motors, power train, hydraulic and electrical components.
  • Uses power washers & spray paint equipment to clean & paint vehicle.
  • Uses instruments and computers to reprogram equipment controllers.


MINIMUM REQUIREMENTS:


Education:

Must have a high school education or GED


Work Experience:

Requires four years of work experience with at least two years experience with Air Compressor related equipment; Must be proficient in at least two mechanical and Electrical systems (i.e. Electrical Controls, engines, hydraulics, etc.) for numerous model lines.


Physical:

Must be able to daily and repeatedly stoop, kneel, bend and climb beside, onto and underneath various equipment to perform diagnosis and repairs; Must be able to effectively see to perform repairs, research technical manuals, and develop written repair work order reports. Must be able to routinely and physically lift/position various parts to perform repairs/service and manually handle parts up to 112 pounds, as well as use mechanical hoist for heavier parts.


Other:

Must be able to effectively write repair activities on customer work orders; Must have cognitive reasoning and problem-solving skills to apply knowledge, written information and verbal instructions in repairing/servicing unusual and/or unknown technical equipment operational problems. Should have exposure to P.C. base equipment and parts information; Can work independently with minimal supervision.



This job description is not intended to be all-inclusive. Your supervisor may request and assign you similar duties. Any major modification of this job role requires Human Resources approval.

Responsibilities:

Please review the job description.

Educational requirements:

  • high school

Desired Skills:

Please see the job description for required or recommended skills.

Benefits:

Please see the job description for benefits.

Apply Now